7 Tricks with threads to embroider better

hace 3 años

Tips and tricks with threads

Today we present you with 7 fantastic tricks with threads, so that you can improve your experience in the art of embroidery. Check them out below...

tips for embroidery threads

1 - Double the thread

Try folding one end of the thread and pushing the fold through the eye of the needle when you are threading the needle. This works especially well when using wool or thicker yarns.

2 - Use the right side of the eye

Some needles are easier to thread on one side of the needle than the other because of the way the needle hole has been stamped. It is not always obvious to see which side of the needle to thread, as the eye can be quite small. If you are having trouble threading the needle, try turning it over and threading from the other side.

3 - Wire length

Try to keep your thread no longer than 50cm as longer lengths can knot or come apart. If you are using a metallic thread, do not cut the thread more than 30 cm, as it separates much more easily and then becomes difficult to work with.

4 - Separating threads

Some yarns need to be separated into the number of strands you want to use. The best way to do this is to cut a length of thread and then gently hold it between your thumb and forefinger about 5cm from one end. Take a strand and gently pull it up. It will easily separate from the other threads.

5 - Combine threads

If you want to sew with more than one thread, you should always separate the threads individually and then combine them again. This will make the strands sit closer together when you sew.

trick with embroidering threads

6 - Try different numbers of threads

Vary the number of strands you use on your needle for different effects and experiment. One strand will give a fine, delicate line that will create softer curves, while four strands will fill in an area using Satin stitch quite quickly and give a raised effect. Practice this on leftover fabric to get the effect you want.

7 - Use thread conditioner

Thread conditioner or beeswax is used to run a piece of cut thread before sewing to help keep it soft, prevent tangling, and help it glide through fabric more easily. This is especially recommended when using metallic threads.

Here you can see the best threads for hand embroidery.

Related articles

Go up